page 2
I. General Information
a. About Your Lock
Each time you press a number, letter, or other character on the keypad of your Model 6124 or 6125
electronic safe lock, it beeps and the red LED flashes. If it doesn’t, check your batteries to make sure they
are fresh and connected properly, then try again. (See Changing the Batteries, paragraph C.)
The lock responds with various beep () sequences to indicate different conditions. The symbols in
examples show the number of beeps you hear. Always wait for each set of beeps to end before entering
another number or letter, or you will interrupt the code sequence.
Important points:
• When programming, you enter new codes twice, to confirm their accuracy.
• Clearing the Lock: If you start to enter a code and make a mistake, you can press * to clear the lock,
or wait 10 seconds and it will clear itself. Note: Do not wait more than 10 seconds between entries
or the lock will clear.
• Error Beep: If you hear a long continuous beep during any programming sequence, you made an
error. Start the sequence over.
• Error Penalty: If you enter five incorrect codes in a row, the lock starts a ten minute penalty time. If
you enter another wrong code during this time, you’ll hear two long beeps, and the lock will not open.
You have no recourse other than to wait ten minutes before entering a valid code to open the lock.
b. PIN Positions
Each code created for use in your lock is assigned a personal identification number (PIN) position. The
Master Code is PIN 0 (zero), the Supervisor is PIN 1, Users are PINs 2 through 8.
If your lock has the
duress feature enabled, User PINs 4 through 8 are automatically disabled and are not available. The Time
Delay Override Code uses PIN 9. If Time Delay Override is disabled, PIN 9 works like a standard User code.
c. Changing the Batteries
No codes or program settings are lost during battery replacement. Carefully remove the keypad housing
by first lifting the bottom edge (closest to the S&G logo) and then easing it off the base. Detach the old
batteries from the terminals. To prevent bending or breaking the holder, support the top of each battery
holder as you insert each fresh battery; Duracell
®
alkaline batteries are recommended. Note: If power is
removed from the lock in Management/Employee mode, the lock powers up in the disabled state.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern