Sargent and Greenleaf 6123 Anleitung zur Fehlerbehebung PDF herunterladen (Seite 3)

PROBLEMS

7) Lock opens intermittently

when using valid codes

8) Lock beeps three times when

code is entered, but doesnʼt

open

9) Unable to delete time delay

10) Unable to set time delay for

more than nine minutes or to

adjust opening window on model

6123 lock

11) After entering the code for a

spring bolt lock, the motor starts,

but the safe door cannot be

opened

12) Lock motor runs continuously

after a battery change, and the

lock stays locked

13) Lock opens okay, but bolt will

not re-extend far enough to lock

safe.

POSSIBLE CAUSE

• Connection of wires to back

of keypad is loose

• Keypad is bad

• Lock is in time delay mode

• Time delay can only be

deleted during the opening

window

• You are using the Supervisor

code (model 6123 only) or

a User Code (either model)

instead of the Master Code

• Lock may be model 6120

• Bolt of the lock is binding

against the door frame or

door strike

• The logic circuit did not reset

properly when power was

restored to the logic circuits

• Batteries are weak

POSSIBLE SOLUTION(S)

• Perform Keypad Connector

Check (#8)

• Replace with new keypad

• Wait for time delay to expire,

then delete time delay—see

lock operating instructions or

consult toll free help line

• Wait for opening window

before attempting to delete

time delay—see lock operat-

ing instructions or consult toll

free help line

• The Master Code must be

used to delete the time delay.

Perform Master Code Check

Procedure (#3)—see lock

operating instructions or con-

sult toll free help line

• Perform Model Check

Procedure (#9)—see lock

operating instructions or con-

sult toll free help line

• Push in on the door while

entering the code; remove the

source of the binding after the

door is open

• Perform Walk Back Procedure

(#5)

• Unplug the wire connector

from the back of the keypad,

leave it unplugged for at least

30 seconds, then plug it back

into the receptacle on the

back of the keypad. The pro-

cessor should reset properly.

• See Battery Check and

Replacement Procedure (#6)

1 2 3 4 5 6

Kommentare zu diesen Handbüchern

Keine Kommentare